Design and manufacture of an indoor paddleboard trainer

Kafeety, Sami (author)
Pannu, Diljot (author)
Abbasi, Omer (author)
Fourie, Johan (thesis advisor)
British Columbia Institute of Technology Mechanical Engineering (Degree granting institution)

Research paper/project

http://rightsstatements.org/vocab/InC/1.0/
© Sami Kafeety, Diljot Pannu, Omer Abbasi, 2018. All rights reserved. No part of this work covered by the copyright heron may be reproduced or used in any form or by any means – graphics, electronic, or mechanical including photocopying, taping, or information storage and retrieval systems – without written permission of the author.
http://creativecommons.org/licenses/by-nc-nd/2.5/ca/

British Columbia Institute of Technology

2018

81 pages

The project commissioned by DOS Watersports requires a development of a functional prototype of an indoor paddle board trainer. Some of the requirements for the paddle board trainer included inertia and variable resistance. The scope of the project was focused solely on the paddle motion and not the user’s ability to balance on the paddle board. The form of resistance was open ended, as well as the budget for the paddle board trainer.

MECH 8290

electronic

Bachelor of Mechanical Engineering