Temperature and humidity distributions in mid-rise residential building suites

Tariku, Fitsum (Fitsum Tariku (Fitsum_Tariku)) (author)
Simpson, W., Ying (author)
(editor)
(translator)

© 2014, F. Tariku and W. Ying Simpson.

14th Canadian Conference on Building Science and Technology, Toronto, Canada, October 29th-30th, 2014. It is essential to design and operate buildings with good indoor air quality as people spend most of their time indoor. Their productivity, comfort and health depend on the quality of the indoor air. In addition to other air quality parameters, indoor humidity and temperature need to be controlled and maintained to acceptable ranges. These conditions may not be uniform within the house/building due to local heat and moisture sources and absence of an effective indoor air mixing mechanism as in the case of in buildings with baseboard heating systems. Localized high humidity creates favourable conditions for localized mold growth, poor indoor air quality and building envelope damage. In this paper, the indoor humidity and temperature distributions within four suites (designated as Suite ‘A’, ‘B’, ‘C’ and ‘D’) in a six-storey multi-residential building are studied. A total of 22 rooms are monitored with indoor temperature and relative humidity data loggers, and the outdoor climatic conditions are measured with a weather station for over a year. The hygrothermal performances of exterior walls in the master bedrooms of the respective suites are assessed. Analysis of the measured data suggests that the temperature variations between the rooms (bedrooms, living room, kitchen excluding bathroom) are relatively low during the summer period (mean temperature difference less than 1oC) compared to the winter period where the variations between the rooms can be as high as 2oC. The excess humidity differences between the rooms, excluding the kitchens, are in the range of 0.2 g/m 3 to 1.0 g/m 3 during both winter and summer periods, whereas the excess humidity fluctuations within the rooms are fairly the same and have standard deviation values between 0.8 g/m 3 and 1.0 g/m 3. Excess humidity is defined as the difference between the indoor and outdoor absolute humidities, quantities that are derived from the simultaneously measured temperature and relative humidity of the indoor and outdoor locations. Hygrothermal simulation results of exterior wall systems indicate that, in a mild coastal climate, the winter average indoor relative humidity shall be below 43% (for a seasonal average indoor temperature of 20oC) to avoid building envelope moisture damage.

http://obec.on.ca/sites/default/uploads/files/members/CCBST-Oct-2014/A6-...